Make sure that you have a Token Ring card that is supported by this driver. Currently the only cards that are supported are those that use the Tropic chipset.
Cards that I personally know to work are:
It is recommended that you use 16KB Shared RAM for the time being.
Cards that may cause problems:
This adapter will, in fact, work fine with the Linux token ring driver. However, you MUST run the card in Auto 16/4 compatability mode. The simplest way to set this is to use the LANAID disks sent with the card and run the command:
LANAIDC /FAST=AUTO16
You should then use LANAIDC
or LANAID
to configure the card according to documentation.
This adapter will NOT work. Do not confuse this card with the IBM Token Ring adapter II (4mbit) which does. It is a DMA/Busmaster adapter for ISA.
You may or may not get this one to work. I have had reports of people running it without problems, and others who get errors left and right.
Currently, none of the IBM PCI adapters are supported.
Currently not supported, but being worked on. This driver should be Full Duplex as well when completed.